Powertrax 3710 Manual do Utilizador descarregar pdf (Página 10)

Figure 2

Install shear pins and spacers

3. Place a spacer into the center of each driver, wide

end toward the teeth if not symmetrical (Figure 2).

4. Press a thrust washer (with grease added) onto the

back of each coupler.

5. Insert a small spring into each of the large springs

and add a lile grease to the coils to hold them together. Set

them aside.

Assembly of the LOCK-RIGHT Parts into

the Dierenal Case

Summary of steps in this secon:

1) Install Ring gear side coupler and washer

2) Install other coupler and washer

3) Install le C-Clip (C-Clips only)

4) Install le driver and spacer assembly

5) Install other driver (non C-Clip); or

6) Install other C-Clip (C-Clips only)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Sem comentários

Powertrax 3710 Manual do Utilizador Página 10