Powertrax 3710 Manual do Utilizador descarregar pdf (Página 21)

Secon 5: Tesng Your Installaon

1. Be sure that the vehicle is safely blocked. Leave the

axle assembly on the jack stands, with both res free to rotate

and the emergency brake o.

2. Put the transmission and transfer case in gear to

lock the drive sha.

3. Rotate one of the res in the forward direcon with

your hand unl it stops, then hold it. That side of the LOCK-

RIGHT is now locked.

4. Rotate the other re in the opposite (reverse) direc-

on. The LOCK-RIGHT should “click” as the coupler aached to

the axle rotates.

5. Rotate the rst re in the reverse direcon and hold

it; repeat step 3, rotang the other re in the forward direcon.

6. Repeat steps 2-4, rotang and holding the second

re to lock the second side.

Secon 6: Driving Your Vehicle

If the foregoing measurements and tests have been suc-

cessfully completed, apply the emergency brake and remove the

vehicle from the jack stands. Your vehicle should now be ready

to drive.

Carefully read and understand the driving informaon

contained in the LOCK-RIGHT Vehicle Owner’s Manual! Safe and

eecve use of your new LOCK-RIGHT-equipped vehicle depends

on knowledgeable operaon, and this can only be done by un-

derstanding its characteriscs before you start. Be careful, and

have fun!

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Sem comentários

Powertrax 3710 Manual do Utilizador Página 21