Powertrax 3710 Manual do Utilizador descarregar pdf (Página 11)

Figure 3

Install couplers (and le C-Clip if so equipped)

1. Install a coupler and washer assembly in the ring

gear end of the dierenal case (over the axle splines if in the

vehicle). See Figure 3. Note that the couplers in some models

may have ats for clearance. If an axle sha thrust block is used,

place it in the center of the second coupler now if the installa-

on is being done in the vehicle. If not, it may be installed later.

2. Place the second coupler and washer assembly into

the other end of the dierenal case (Figure 3).

3. For C-Clip dierenals only: Place a C-Clip with the

ends poinng down into the ring gear side axle sha end groove

and pull the re out sharply to seat the clip (Figure 3). Then,

carefully push the other axle into the second coupler splines unl

the end of the axle sha is even with the coupler surface. Keep

the coupler seated in the case. Note: The ring gear is removed

for clarity. Ordinarily, the dierenal case is in the vehicle and

the ring gear is in place.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Sem comentários

Powertrax 3710 Manual do Utilizador Página 11